Note the small magnet laying on the table. This would vibrate when I applied AC to
the coils from the variable isolation transformer.
When I applied 115 volts AC into the red circuit, I got 50 volts out the blue curcuit.
When I applied 115 volts AC into the blue circuit, I got 50 volts out the red curcuit.
Coils bolted onto base boards, glued, taped, and wired.
Ready for testing.
Test set-up. Pop-cycle stick on top of large coil supports small magnet wire away from coil.
Wiring. Actually the large terminal strip is wired as mirror image of schematic two.